Видео

We are not able to research Renaults to know if you can get by without using the crossover when installing a component speaker. If the woofer and tweeter are connected to the same amp channel in your Twingo, then the crossover must be installed. We recommend checking with a local installer for help with your crossover question

@crutchfield Installed the in-line crossover today and works perfectly. Thank you for your reply!

It sounds like you are using an amp that has a remote level controller connected to this receiver. This radio's subwoofer controls should not impact the ability to use the controller and it is likely that either the amp, controller, or controller cable are causing the issue. Troubleshooting may be needed to help figure out which is the culprit. If you purchase your gear from us, you can contact our technical support for help using their toll free phone number that is included on the order invoice.

How does it sound? Can you also test your dual 8"s with them facing rearward to see if there is a noticeable difference?

You're certainly welcome! 🙂

That's great! Did you also upgrade the factory speakers?

It sounds like the mirror/camera setup used a 5 pin connector to attach the camera to the mirror and if that is correct, then you will need to identify the purpose of each of the 5 pins/wires to properly splice in the new camera to determine which was taking in the reverse trigger, video signals, and other purposes. We do not research the pin layout on such cameras to help with this, but we do know that if one of the pins was designed to take in a reverse gear trigger, then the convenience wire that came with the new backup camera can be used to provide that trigger from the reverse light circuit

The Rockford Fosgate Prime series of amps are slotted in the middle of the tiers between Punch with Power being the Rockford's premium options that we carry, that is correct.

You can, even if your vintage receiver options do not have a subwoofer RCA output. It's a good idea to use a modern subwoofer with a speaker-level input feature like the SVS SB-1000 Pro in the link below. Though this feature is not available on all powered subwoofers, we do carry a wide selection of options from small to large that do! www.crutchfield.com/I-rYALc166/p_946SB1KPGB/SVS-SB-1000-Pro-Gloss-Black.html

That's right! A fellow advisor let me know after they performed the update on their own Sony radio. Totally stoked, as that is a feature I think many people will take advantage of!

Thanks in advance

We have not been able to compare either unit to a PS5. Chances are that the DP-UB820 would be needed to be equal to or better than a PS5. As for streaming Netflix, the differences depend on the TVs abilities. If the TV does not support HDR or at least does not support Dolby Vision HDR, then the DP-UB820's ability to stream Netflix with Dolby Vision and re-encode it to something the TV supports, will help provide better colors than the TV streaming the content.

@@crutchfield awesome. Thank you much. Been debating on getting one but I already have a ps5 and usually stream. So trying to see the pros and cons of getting the 820 and the ways I can use it

Good planning! What brand and model TV are you using?

@@crutchfield right now I have a Samsung q90T and ps5. And Sonos arc surround system. Problem is the Samsung doesn’t do Dolby vision and from my understanding won’t allow dts pass through. Sonos plays dts but not dtx. So for my man cave I’m trying to make sure whatever I get will allow me to use Dolby vision, atmos and Atleast allow dts. Planning on getting the lg g4 in the future.

We are stoked you enjoyed it! Keep us updated on what you think of the Carina's once you have them broken in and have given them a good critical listen. I know I liked them. Pretty much anything with the folded ribbon tweeter sounds sweet to my ears!

Unfortunately, that older JVC model did not offer built-in Bluetooth.

That does sound frustrating, I do apologize. What type of device/browser are you using to play the RUclips videos?

I’m using an IPhone 13 Pro Max.

Are you using the Kenwood WebLink app to play RUclips on the Kenwood DMX905S?

Yes I have tried it with the Weblink App. It doesn’t work for me. I haven’t tried using an android device yet. I will try that next.

Just to be thorough, you are using the Black USB port when connecting an iPhone to the radio to run weblink? If you are and you have tried different youtube videos, then this is a mystery to us and we recommend contacting technical support for help. If you purchased the receiver through us, you can contact our technical support for help troubleshooting the playback issue.

You're welcome. Good luck with your install.

Hi Nicholas , sorry to hear your installation isn't going better. What's the year, make, and model of your vehicle? What model radio are you trying to install?

You're welcome, Ronald. Are you planning to install specific speakers?

@crutchfield Well not yet, I'm still troubleshooting what's wrong with my speakers. I'm not sure if it's my reciever or speakers so I'm going to take my multimeter to the speakers to test them is my first step.

That sounds like a solid plan. It is difficult to properly upgrade a system without first knowing what is working and what isn't. Keep us posted!🤘

We are seeing more and more plastic fabrication these days for sure likely due to flexibility in design and use. Are you considering speakers for a specific vehicle?

The best option there depends on the camera you use. And in some cases, even the radio/camera combo so you do want to be sure you follow the model specific instructions.

So both methods are an option, correct? I wish I understood if there were a functional difference.

Both methods can work well. Not all vehicle radio harnesses provide that reverse wire connection though, so that isn't always an option.

​@@crutchfieldGot it, thanks.

You're welcome.

Thanks! Are you considering a pair of Sonos Ace headphones?

Less exposed to sunlight, speakers in doors last a bit longer if the weather seals don't give way and then moisture kills the speakers from behind.

We are still seeing quite a few rear deck speakers in current sedans. Were you hoping to add speakers to a specific model?

Hi Cicada, sounds like you love bass! What is the RMS power rating per sub? How many voice coils does each sub have? What is the impedance per coil?

Hi again! What's the impedance option for your subs?

@@crutchfield series 4 ohms, parallel 1 ohms

Are you more concerned about sound quality or bass output? Most Mojo 15"s can handle around 750-watts RMS. If you wire them to 4-ohms for the best sound quality, you can use the Memphis MJP3000.1 below to deliver around 1275 watts into the 4-ohm load for the best of both worlds! www.crutchfield.com/I-rYALc166/p_953MJP3000/Memphis-Audio-MJP3000-1.html

For this model, when voltage returns to a safe level, power to the equipment should be automatically reconnected. If you got the unit here, please call our Tech Support. Their direct number is on your invoice.

The Ace headphones are very versatile. They are not Teams certified; but do work with Bluetooth and allow you to connect two Bluetooth devices and switch between them easily. Let us know what you think.

This subwoofer was discontinued back in 2022 and we have since sold out of the units we got. We do not know what it would be selling for today

The JL Audio JD and RD series amps are very similar in overall performance and specs, and the difference really comes down to the overall design. The RD series has all of the wiring connections on the same side, as well as top mounted controls for the various settings, which helps make for easier installation and setup.

Their differences are in the clarity of the sound because the A12 MKII model has an improved damping factor and higher S/N ratios. It also has more analog and digital audio inputs as well as a USB input. It also has A/B speaker terminals with the ability to run both A and B at the same time (can only run A or B but not both on the A11 MKII). The A11 MKII does have one advantage; it supports aptX HD while the A12 MKII only supports up to aptX (no aptX HD)

Hello, thank you for reaching out to us we are here to help you as best as we can. I would encourage you to contact us by phone at 800-309-2075, so that we can better assist you. We offer help in English and Spanish.

This speaker does not have a way to output audio to a different speaker. It only has inputs to take audio in from external devices. This means that if you have another speaker which does everything you want and that other speaker has an audio output, then you can use this JBL with that other speaker.

If you want to turn the screen completely off, according to the manual, start by pressing the options button. Then there should be a "monitor off" icon on the screen towards the bottom that looks like a screen with a slash through it. Just touch that icon and the screen should turn off. You can then touch any part of the screen to turn it back on.

We do not have anyone here that can read your post. If you can repost it in English, we will be happy to help

Nice! How do you like the Marantz? What type of speakers do you use with it?

@@crutchfield I've got a full set of Tannoy Eclipse series with a wharfdale 10 sub and it sounds magical... Going to upgrade the speakers eventually though

What type of vehicle do you have?

The name of the app is Kenwood Music Control but it appears the app is no longer available because it cannot be found in the Google Play Store

They continue to be better than some and not as good as others. Is this a new addition to your system or are you upgrading subwoofers?

@@crutchfield It’s a new addition

Nice! What is your exact setup? What type of bass are you looking for?

It’s actually a whole new set up for my son’s room. I want a kind of “budget” system, but something that can still impress. I’m looking at a Sony STR-AN1000 for the receiver, the Klipsch RF 8000FII or Polk R700’s, and the SVS SB-1000 Pro or maybe the Polk HTS10 and maybe the Polk ES-10’s for the rears (Not sure I want to go all Polk, since I’m considering the Klipsch and if the SVS sounds better than the HTS-10) My son watches some movies but gaming and music are his go to choices. I have to admit I get most of my “advice” from Andrew Robinson. Been following him since his Home Theater Review days.

In my opinion the SVS SB-1000 below is a true performer and would provide better bass than the Polk HTS10 due to having a larger woofer and more RMS power, by around 225-watts. I know that Andrew Robinson really dug the SB-1000 when reviewing them with the SVS complete surround sound system. Using the Klipsch 8000's for your mains and matching center channel will be a recipe for success! www.crutchfield.com/I-rYALc166/p_946SB1KPBA/SVS-SB-1000-Pro-Black-Ash.html

Hi Ajumal, looks like you can search for authorized Alpine dealers in the UK here: uk.horn.eu/en/UK/WHERE_TO_BUY

Do you also want to replace the small tweeters up front? Will you be adding an amplifier to power the new speakers?

If you don't have a camera installed and the radio's reverse wire isn't connected, then the radio won't switch over to the rear camera input when the vehicle is in reverse.

Unfortunately, it does not support wireless Bluetooth connectivity. However, you can connect it directly to the optical digital audio output on a TV.

If you can get power to the camera and get a reverse gear trigger to the radio through cables closer to where they are installed, then you will not need to use the convenience wire